We have been getting a lot of requests for the High Torque in the rear exhaust version, so here it is. It has the identical same power and identical same wide power band as the side port High Torque does and, just like the side port High Torque, it is extremely reliable and an extremely long lasting engine with 4 main bearings. I have run about 5 gallons of fuel through it on the water brake dyno, still with no signs of wear. You can get it with a Quickdraw piston or the new RCMK cast rear exhaust piston, they run the same and they are interchangeable. The RCMK piston will be cheaper to replace.
Like the side port High Torque, the engine comes as a package with engine, Hot pipe and silencer. You need to specify the head pipe angle, we can make them anywhere from zero to 20 degrees. The flex joint gives you additional adjustment if needed; it will give you as much as 8 degrees up or 8 degrees down. The engine package does not come with the starter pulley, collet or motor mounts.
The engine is shown with Zenoah style motor mounts (not included), notice that they have to be trimmed to clear the carburetor. Also notice that the engine can be set very low in your boat. I am not planning on putting a recoil starter on it, but as you can see any method used to do this on any of the other rear exhaust engines can be applied to the Quickdraw if you want to do that.
The engine comes to you already broke in and dyno tested. It only comes as a complete package; Engine, Pipe and Silencer.
RTR HT Rear Exhaust engine package with pipe & silencer . . . . . . . . . . . . . . . . .
$795 with cash discount*
(*cash means personal check, money order or cashiers check. Personal check must clear before shipping. Call or email us for details)
RTR HT Rear Exhaust engine package, same as above,
paid with credit card or Paypal . . $850
The starter pulley is $35, it is a cut down Speedmaster starter pulley and this option includes the collet in either round or square drive.
A cut down Zenoah collet by itself is $16, it comes in either round or square drive.
A pretrimmed set of motor mounts with isolators are $65, or you can trim your own Zenoah style motor mounts with a hacksaw and a file, there is not much to it.
